On your garage door, there are 2 springs. The heavy length springs that are affixed to the top part of the door are called the expansion springs or side-mounted springs. The springs that are affixed to a steel plate that is fixed and placed over the facility of the framework and parallel to the surface area of the frame are called the torsion springs. The torsion springs work on the fundamental principle of tension and have wires that are affixed to each side of the door on the lower panel. When it is time for a garage door spring replacement you can change them by yourself if you know the procedure or have a specialist get the job done. For more information visit the site.



It is very important to note that doing a spring replacement can be dangerous if it not done with the best precautions as a result of the tension that is in the spring You have to utilize severe safety measure due to the fact that you can lose your fingers, eyes, hand, arm or legs, or perhaps your life. This is why most will certainly leave this garage door repair to a professional.




- Before you do the replacement launch the stress in the old spring.

- Do not touch the cord drum

- Make sure that you never ever wind off or wind up the spring using a screwdriver

- You should first always put a bar that is well-fitting right into the winding core before you touch a setscrew. Do not make use of an outlet or box wrench for the set screw.

- Keep bench in the cone while doing spring replacement.

- When the spring is wound never ever touch the bracket.



The treatment to replace the garage door spring replacement is:


- Stop the power supply and disconnect the opener's power cord. Remove it from the garage door. Some older openers you need to eliminate a fuse or flip the breaker.

- Make sure that you have the best torsion spring to change the old one. Examine the type and dimensions of the brand-new one to the old spring. Stay clear of touching the winding cones or getting hold of the torsion spring.


- See to it that you mark each end of the shaft in order to help level the door after the new spring installation.

- The Wind off the unbroken spring then undo and eliminate the screws that are securing the cones to the brace.

- Replace and reinstall all of the hardware.

- Ensure that you wind up the replaced spring.

- Examine the garage door for level and equilibrium.

- Apply some lubricant to help reduce the friction.

- Attach the garage door opener and check to see if it works.

Post Navigation